Symbols; Safety Information - Amprobe ACD-31P Mode D'emploi

SyMboLS

�
Battery
�
Double insulated
�
Direct Current
�
Alternating Current
Conforms to relevant Australian
�
standards.
Do not dispose of this product
�
as unsorted municipal waste.
Application around and
�
removal from hazardous live
conductors is permitted

SAfEty INfoRMAtIoN

• The ACD-31P and ACD-41PQ Digital Clamp meters conform to en61010-1:2001;
en61010- 2-032:2002; CAT iii 600 V, class 2 and pollution deg.2
• This instrument is en61010-1 certified for installation Category iii (600V). it is
recommended for use in distribution level and fixed installations, as well as lesser
installations, and not for primary supply lines, overhead lines and cable systems.
• Do not exceed the maximum overload limits per function (see specifications) nor the
limits marked on the instrument itself. never apply more than 600 Vdc/600 V ac rms
between the test lead and earth ground.
� Warnings and Precautions
• Before and after hazardous voltage measurements, test the voltage function on a
known source such as line voltage to determine proper meter functioning.
• Disconnect the test leads from the test points before changing meter functions.
• Disconnected from the meter's test leads before measuring current.
• inspect the Clampmeter, test leads and accessories before every use. Do not use any
damaged part.
• never ground yourself when taking measurements. Do not touch exposed circuit
elements or test probe tips.
• Do not operate the instrument in an explosive atmosphere.
• To reduce the risk of fire or electric shock, do not expose this product to rain or
moisture.
• The meter is intended only for indoor use. To avoid electrical shock hazard, observe the
proper safety precautions when working with voltages above 60 VDC or 30 VAC rms.
These voltage levels pose a potential shock hazard to the user.
�
Refer to the manual
�
Dangerous Voltage
�
earth ground
�
Audible tone
�
Complies with eU directives
�
Underwriters laboratories.
5