OHAUS Catapult 1000 Serie Manuel D'instructions page 7

Catapult 1000 Series Scales EN-5
3.3 Changing Units of Measure
Cal
Press the UNITS button to display the next available measuring unit.
3.4 Auto Shut-Off
To extend battery life, the scale will automatically turn off after approximately four
minutes of inactivity. This feature is only active during battery operation.
3.5 Dynamic Weighing
Cal
With the platform empty, short press the UNITS button
to cycle through the units. Dynamic mode is active when
the indicator • is flashing.
Place a mass on the platform. The scale will show "-A-".
Off
NOTE: If using a container, press ON/ZERO to tare the
weight and return to zero.
With a mass on the platform or container, a short press of
Cal
UNITS will start the averaging countdown from 5
seconds.
The averaged weight is then displayed. The indicator •
stops flashing when the process is complete.
The display will hold until a button is pressed.
Cal
To repeat the process press UNITS with a mass on the
platform or container.
To Exit, remove the mass from the platform or container and
Cal
press UNITS .
TM
3.6 Weight Alert
Cal
With platform empty, press the UNITS button until the lb unit displayed.
The digits will start to flash if the weight on the pan is over 70 lb.
If the weight on the pan is over 150 lb, the digits will stop flashing.
NOTE: Weigh Alert TM is only available on C11P75 model. Weight Alert TM is available
only in Lb mode without Dynamic Weighing. Make sure that the "lb" indicator is
turned On and the "•" dynamic weighing indicator is turned Off.