Features; Precautions; Power Supply - Sony YS-W270A Mode D'emploi

Features

Precautions

Power supply

Foreign objects
6
(GB)
The YS-W270A camera adaptor can be connected to a Sony SSC-series
camera (multiplex transmission capability), providing it with power and an
external synchronization signal while also transmitting the video signals
from the camera to a monitor.
The adaptor has 4 camera input connectors and 8 video output connectors,
allowing for connection of up to 4 cameras and 8 monitors.
If you are using an SSC series camera, see "Notes on Connections" on page 10
(GB).
• Only a single 75-ohm coaxial cable is needed to send synchronization
signals, video signals and power.
• If you connect multiple cameras that have different synchronization
methods (VS or VD), they can be synchronized.
• The SYNC MODE switch allows you to switch the synchronization mode
according to the source signal.
– In the PRIMARY mode you can output synchronization signals from
the YS-W270A.
– In the SECONDARY mode you can connect more than one YS-W170A
or YS-W270A using external synchronization signals. There is no
image disturbance when you switch the camera. (For details on
connection, see the Connection section.)
• The YS-W270A has a built-in cable compensation circuit that allows you
to switch the video signal compensation level according to the cable
length.
• The YS-W270A can be used with both VS and VD cameras, which
means the adaptor is compatible with all camera models in any series. If
you connect the adaptor to a VD camera, you don't need to adjust the H-
Phase at the time of installation.
• You can output the video signals to two systems.
Be sure to operate the camera adaptor according to the power requirements
outlined under "Specifications" on page 14 (GB).
Be careful not to spill liquids, or drop any flammable or metal objects into
the body of the unit.