Connecting Antennas; Connecting The Am Loop Antenna - Yamaha DRX-730 Mode D'emploi

Connecting antennas

To listen to FM and AM radio, you must connect the
supplied antennas to the DRX-730. If radio reception
is poor in your area or you want to improve reception,
you can connect outdoor FM and AM antennas.
Consult an qualified antenna installer in your area for
more details.
■
Antenna grounding
For maximum safety and minimum interference,
connect the AM ANT GND terminal to a good earth
ground, such as a metal stake driven into moist earth.
Indoor FM antenna
(supplied)
HDMI
AM
ANT
GND
FM
ANT
75
UNBAL.
P R P B
Y
R OUT
VIDEO COMPONENT
OPTICAL
T IN
AUX DOCK VIDEO OUT DIGITAL
Connecting the FM antenna
1
Connect the supplied indoor FM antenna to
the DRX-730's FM ANT jack.
2
Site the antenna away from the DRX-730,
speaker cables, and power cables.
Notes:
• Do not connect the power cable to the DRX-730
until all other connections have been completed.
• Before deciding where to install the antennas
permanently, tune in to an AM or FM radio
station and adjust the position of the AM or FM
antenna, respectively, to find the best reception.
• If you connect an outdoor AM antenna, connect
the supplied AM loop antenna as well.

Connecting the AM loop antenna

1
AM loop antenna
(supplied)
2
• If both of the wires on your antenna are black, this
Earth
ground
• If one of the wires on your antenna is white and
3
Chapter 2: Getting Started
Assemble the antenna's stand as shown.
If you intend to mount the antenna on a wall, you
do not need to assemble the stand.
Push open the AM ANT terminal lever, insert
the AM loop antenna's wires into the holes,
and then close the lever.
means they are not polarized and can be
connected either way around.
the other one is black, connect the white wire to
the AM ANT terminal, and connect the black
wire to the GND terminal.
AM ANT terminal
White
Black
Site the antenna away from the DRX-730,
speaker cables, and power cables.
GND terminal
11
En
2