Trisa 7713 Mode D'emploi page 33

After switching on the mixer motor the cooling aggregate may only be switched off
when the preparation of the ice cream has been finished. In case of switching-off or
power failure during ice-cream preparation, the compressor will start cooling after rerunning
only with a waiting period of 5 minutes. This is caused by an integrated safety circuit. This
may result in an insufficient preparation of the ice cream
Important
Only fill in the mixture up to 3 cm below the edge of the bowl, as the mixture will
increase in volume because of the cooling!
Remark:
Depending on recipe, temperature and quantity, the period of time for preparation
may vary. It takes approx. 20 - 40 minutes.
If the ice cream is not solid enough, another period of time, e.g. 5 minutes, may be selec-
ted after completion.
5. Switch on the device by pressing down
the cooling ON / OFF switch (9).
Tip:
At first, switch on device and then start
preparing ice cream.
So cooling is already at full power when
filling in.
6. Now slowly fill in the prepared mixture into
the ice cream maker through the filler
opening of the lid (3).
7. Select the desired period of time on the
display by pressing the select button (14)
(possible period of time are 5, 10, 20, 35
or 40 minutes). The desired period of time
will now flash in green.
- 31 -