Kuppersbusch EDL 9750.1E Mode D'emploi page 12

Instructions for use
You can activate or deactivate the cooker
hood by operating the functions shown in
the diagram.
Switch on the extractor fan a few minutes
before you start to cook in order to ensure
that a steady air flow has been established
before fumes appear.
Allow the extractor fan to run for several
minutes after you have finished cooking
(between 3 to 5 minutes) in order to expel
all the grease from the outlet duct. This
prevents the return of grease, smoke and
smells.
ON/OFF
ON/OFF
Decrease selected
funtion
Filter saturation
indicator
Setting The Extraction Time
• Turn the hood on and select the required
extraction speed
• Select the programming time by pressing Timer.
• Each press of the button increases the
programming time by 10 minutes, up to a
maximum of 80 minutes.
• To reset the programme, wait for over a second
and press the Timer button again.
• The speed and extraction time are displayed with
the LED indicator.
• The intensive speeds 6, 7 and 8 cannot be
programmed. These must be selected manually
and have a maximum duration of approximately
10 minutes.
Receiver
Emitter
Light
Increase selected
funtion
Timer
LED
Filter Saturation "F"
• Clean the filters when all lights of the LED indicator
begin to flash followed by an acoustic signal.
• Press "Filter Saturation" to reset this feature
Cleaning and maintenance
During cleaning and maintenance work,
make sure the safety instructions are
complied with.
Cleaning the hood body
• If your kitchen hood is made of stainless
steel, use proprietary cleaners mentioned
in the product instructions.
• If your kitchen hood is painted, use
lukewarm water and a neutral soap.
• Never use metallic scourers, nor abrasive
or corrosive products.
• Dry the kitchen hood using a cloth that
does not produce fibres.
• Do not use vapour cleaners.
Cleaning the metal filters
To remove the filters from their fittings, press
lightly on the locks and then pull them off.
The metal filters can be cleaned by soaking
them in hot water with neutral detergent until
the fat dissolves and then rinsing them under
the tap or using special anti-grease products.
They can also be washed in a dishwasher.
In this case, it is advisable to stack them
vertically to avoid food residues to stick to
them.
Cleaning in a dishwasher may damage the
metallic surface (blackening it), although this
will not affect its fat retention capacity.
Once clean, leave them to dry off and then fit
them onto the kitchen hood.
Changing light bulbs
For changing the light bulbs please contact the
manufacturer's nearest Technical Service.