kiwy SF01 Mode D'emploi page 16

- Fasten the seat belt to the relevant buckle (Fig. 35).
- Make sure the belt is not twisted.
- Tighten completely the diagonal section of the belt by pulling it with
force and making it recover the slack inside the retractor.
- Close the two clamps, placed on both sides of the base.
- Ensure that the seat is securely fastened in the car seat.
- Release the harness buckle by pressing down on the red button
(Fig. 17).
Loosen the harness belts by pressing the push button located at the
middle front of the seat (Part "L") and pulling forward the shoulder belts
from above or below the shoulder strap pads (Fig.18).
CAUTION: the shoulder straps and the crotch belt pads have a fixed
length that cannot be adjusted.
Place the child between the harness belts and fasten the harness belts
combining the two tabs (Fig. 19) and inserting them into the buckle
until you hear a 'click' , which confirms they're correctly fastened (Fig. 20).
Place the harness straps as indicated in Fig. 22, on the shoulders (a) and
the pelvis (b), and the buckle (c) between the child's legs.
Pulling the frontal adjustment belt (Part "C"), tighten the straps making
them adherent to the child's body.
NOTE: Too much tension can be fastidious for the child with the risk that
the latter attempts to get rid of it.
For this reason, the adjustment of the belts must simply eliminate any
excessive slack.
By pulling on the adjusting lever (Part "N"), you can change the
inclination angle of the child seat (Fig. 32).
Removing the child seat
The SF01 Q-fix seat can be removed by pressing on the push bottons
located on the sides of the Isofix arms, to disconnect them from the
14