Accessories; Service And Repairs - Leister WELDPLAST S2 Instructions D'utilisation

Accessories

Only Leister accessories may be used.
Stand
Maintenance
• Check power supply cord (14) and plug for electrical and mechanical damage.
• Clean the extruder nozzle (32) of welding residue every time the welding shoe is changed.

Service and Repairs

• Repairs should only be carried out by authorised Leister service points. These guarantee a professional, reliable
repair service within 24 hours, using original replacement parts according to the circuit diagrams and
replacement part lists.
• If a service message with the service code 1 appears after the WELDPLAST S2 is turned on,
the carbon level should be checked by an authorised Leister service point and, if necessary,
the carbon brushes of the drive changed.
• The message can be hidden by pressing the Select key (28)
• The hand extruder may continue to be operated for a short time.
• If the carbon brushes are not exchanged in good time, the drive will operate until it reaches
the mechanical carbon shut-off point. No error message will appear on the display, but the
drive will no longer operate.
Warranty
• For this tool, the guarantee or warranty rights granted by the relevant distributor/seller shall apply. In case of
guarantee or warranty claims any manufacturing or workmanship defects will either be repaired or replaced by the
distributor at its discretion. Warranty or guarantee rights have to be verified by an invoice or a delivery document.
Heating elements shall be excluded from warranty or guarantee.
• Additional guarantee or warranty claims shall be excluded, subject to mandatory provisions of law.
• Warranty or guarantee shall not apply to defects caused by normal wear and tear, overload or improper handling.
• Warranty or guarantee claims will be rejected for tools that have been altered or changed by the purchaser.
28
Transportable welding rod de-reeler
• The de-reeler is designed for rolls of welding rod
with Ø 300 mm.
• To ensure that the filler rod is unwound as smoo-
thly as possible, it should be fed through the
specially designed eyes (41).
41
.