oticon Alta2 Pro Instructions D'utilisation page 33

This Class B digital apparatus
complies with Canadian ICES-003.
Note: This equipment has been
tested and found to comply with
the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used
in accordance with the instructions,
may cause harmful interference to
radio communications. However, there
is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
64 About Start up Handling Options Warnings
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
– Reorient or relocate the
receiving antenna.
– Increase the separation between
the equipment and receiver.
– Connect the equipment into an
outlet on a circuit different from that
to which the receiver is connected.
– Consult the manufacturer or an
experienced radio/TV technician
for help.
More Info
Oticon declares that this hearing instrument is
in compliance with the essential requirements
and other relevant provisions of Directive
2014/53/UE (RED).
Declaration of Conformity is available at the
manufacturer.
Manufactured by:
Denmark
Waste from electronic
equipment must be
handled according to
local regulations.
Imported and
Distributed by:
Audmet Canada Ltd
1600-4950 Yonge St
Toronto, ON M2N 6K1
www.oticon.ca
65