Electric Motor Precautions - Lavorwash PWR4000 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Electric Motor Precautions

♦ DO NOT directly spray electric motor, as shock hazard could occur.
♦ DO NOT allow electric plug to get wet during operation. PLEASE
USE WITH CAUTION!
♦ Make sure the unit is in the off position before plugging in.
♦ Do not touch plug with wet hands.
♦ Make sure that you are using the correct
voltage and phase
♦ Do not modify the plug provided with the
product. If it will not fit the outlet, have a
proper outlet installed by a qualified electrician.
♦ Do not use any type of adaptor with this product.
It is recommended to connect your electric pressure washer to a
ground fault circuit interrupter. This engine must be grounded. If it
should malfunction or breakdown, grounding provides a path of least
resistance for electric current to reduce the risk of electric shock. This
product is equipped with a chord having an equipment grounding
conductor and a grounding plug. The plug must be plugged into and
appropriate outlet that is properly installed and grounded in accordance
with all local codes and ordinances.
DANGER - Improper connection of the equipment grounding conductor
can result in a risk of electrocution. Check with a qualified electrician
or service personnel if you are in doubt as to whether the outlet is
properly grounded.
Extension Chords
Extension chords are NOT recommended to be used with this product.
If an extension chord must be used the following requirements should
be met:
♦ Use only 3 wire extension chord that has a three prong grounding
type plug with the applicable amperage to match the pressure
washer being used.
Use only extension chords that are intended for outdoor use. These
extension chords are identified by a marking "Acceptable for use with
outdoor appliances; store indoors while not in use" Use only extension
chords having an electrical rating not less than that of the product. DO
NOT use damaged extension chords and DO NOT yank on any chord
to disconnect. Keep chord away from heat and sharp edges. ALWAYS
disconnect the extension chord from the receptacle before disconnect-
ing the product from the extension chord. Extension chords MUST be
connected to a grounded outlet equipped with a GFCI (Ground Fault
Circuit Interrupter). There is risk of electrocution if the extension chord
is not connected to a grounded outlet equipped with a GFCI.
6
Pressure Washer Operation Manual

Publicité

Table des Matières
loading

Table des Matières