Tool Assembly - Milwaukee 6580-20 Manuel De L'utilisateur

WARNING!
To reduce the risk of injury,
always unplug tool before attach-
ing or removing accessories
or making adjustments. Use only
specifically recommended acces-
sories. Others may be hazardous.
Removing and Replacing Quik-Lok
Cords (Fig. 1) Cat. No. 6580-20, 6581-20,
6702-20, 6703-20, 6706-20, 6707-20,
6708-20, 6791-20
MILWAUKEE 's exclusive Quik-Lok
provide instant field replacement or
substitution.
Fig. 1
1. To remove the Quik-Lok
cord nut 1/4 turn to the left and pull it
out.
2. To replace the Quik-Lok
connector keyways and push the con-
nector in as far as it will go. Turn the
cord nut 1/4 turn to the right to lock.
Installing Driving Mechanism
Cat. No. 6706-20, 6707-20, 6708-20
Install the final driving mechanism accord-
ing to the instructions included with the
tool's attachment.

TOOL ASSEMBLY

®
®
Cords
®
Cord, turn the
®
Cord, align the
7
Installing and Removing Bits (Fig. 2)
TEKS Ramp-Off Locator Assembly
The locator assembly must be removed
when changing bit sizes.
Fig. 2
Ramp-off
sleeve
1. Unplug tool. To remove the locator as-
sembly, turn the ramp-off sleeve while
pulling it away from the tool.
2. Pull out the magnetic socket and re-
place it with a new socket.
3. Push the locator assembly onto the nose
of the tool until it snaps into place.
Installing and Removing Bits (Fig. 3)
Drywall Ramp-Off Locator Assembly
Fig. 3
Ramp-off
sleeve
Locator
1. Unplug tool. To remove the locator as-
sembly, turn the ramp-off sleeve while
pulling it away from the tool.
2. Push insert bit into bit holder until it snaps
into place. Push the bit holder into the
nose of the tool until it snaps into place.
3. Push the locator assembly onto the nose
of the tool until it snaps into place.
Magnetic socket
Locator
Bit holder
Insert bit