Water Hardness - SilverCrest SDR 1100 B2 Mode D'emploi

If there is no more water in the water tank
steam lever is pressed
♦ Remove the plug from the mains power socket.
♦ Wait about 10 seconds.
♦ Slowly open the safety valve
a few seconds until the hissing of the water vapour stops.
♦ Fill the water tank
♦ Reclose the safety valve
If the mains water at your locality is rated as hard, it is recommended that you
mix the mains water with distilled water. Otherwise, the appliance could calcify
prematurely and clog the steam nozzle
To extend the optimal functioning of the appliance, mix the mains water with
distilled water as per the following table.

Water hardness

very soft/soft
very hard
The water hardness level of your tap water can be queried at your local water
works.
SDR 1100 B2
. The water tank must be filled as follows:
with water.
3
8
Ratio of distilled water
medium
hard
3 , no steam will come out when the
. Before fully opening up the valve, wait
8
.
.
6
to mains water
0
1:1
2:1
3:1
GB │ IE │ NI │ 9 ■