Display Overview - Greenlee Marker-Mate EML100 Manuel D'instructions

Display Overview

Note: x's shown in the figures in this manual indicate numeric readings on the display.
LCD indicates:
• Mode: SCAN mode (with detected marker type shown), or single marker mode
(i.e., Power, Water, etc.) (Figures 12 and 13)
• Numeric indication and bar graph (Figure 3)
• Gain setting (Figure 11)
• Volume adjustment for speaker response (Figure 4)
• Estimated battery life in hours and low battery warning (Figure 2)
• Time-out feature with disable (Figure 7)
ON/OFF Switch
When the EML100 is turned on, the display will first show the firmware version and then
the estimated battery life remaining (Figure 2). After the Power-On Sequence, the unit
will default to the mode and settings that were used last. For example, if the unit was last
used to locate Gas markers with the Volume set on Low, it will return to the same settings
(Figure 3).
VERSION
BATTERY
Figure 2. Version and Battery
NON-PTBL
Figure 1. EML100 Display Panel
x.x
xx%
65
SCAN
SCAN
EXIT
GAS xx
zzzzz
Figure 3. Sample Display
EML100
7