Operation - Greenlee Marker-Mate EML100 Manuel D'instructions

GAIN – HI – LO Keys
Menu Navigation
The HI – LO (st arrows) are used to navigate through menus while using the MENU key.
Refer to the "MENU Key" section above.
Pinpoint Feature
The HI – LO (st arrows) are used to toggle the Pinpoint feature ON and OFF. The
advanced Pinpoint feature allows the adjustment of the detection threshold, making it
possible to narrow the detection area to a precise location (Figures 10 and 11). Refer to
"Pinpoint Feature" in the "Operation" section.
GAS
zzzzz
Figure 10. Sample Gas Display
EXIT Key
Mode Selection
The EXIT key is used to exit the MENU screen. (Refer to the "MENU Key" section above.)
SCAN / Specific Mode
The EXIT key may be used to toggle between SCAN and the type of marker being detected
(Figures 12 and 13).
GAS
zzzzz
Figure 12. Sample Display

Operation

Note: After the Power-On Sequence the unit will default to the settings last used.
Normal Operation
To locate a known type of marker (i.e., Gas, Power, Water, etc.):
1. Press the ON key and allow the unit to complete the Power-On Sequence that shows the
Firmware version and estimated battery hours. Replace batteries if necessary. (Refer to
the "Maintenance" section.)
2. Press the MENU key.
Press the s or t key to select the VOLUME level desired.
3. Press the MENU key again to access the MODE Select menu.
Use the s or t key to select the desired mode.
4. Press the MENU key again to select the POWER Save menu.
Use the s or t key to set an automatic shut off time or to turn the Power Save Timer
off.
5. Press the MENU key again to view the estimated BATTERY HOURS remaining.
6. Press EXIT to begin searching for the selected type of marker.
Note: These settings will be saved and used the next time the unit is turned on.
10
xx
xx
GAS xx xx%
Figure 11. Gas Pinpoint Mode
GAS xx
zzzzz
Figure 13. SCAN Mode
SCAN