Hoover ACENTA Mode D'emploi page 8

acenta_HEPA_2007_V2.qxd
CHANGING THE PAPER
BAG (7)
The bag check indicator will show red
when the bag needs replacing.
For true bag check indication the power
control must be set to maximum (fully
to the right).
DO NOT overfill the bag.
To change the bag:
1. Lay the cleaner on a flat surface.
2. Remove bag door.
3. Remove bag by pulling bag collar
from hose inlet using tab as shown.
The bag will self-seal.
4. Fit new bag by first folding back the
bag corners and sealing flap as
shown.
5. Locate bag collar in front of tabs in
bag housing as shown, then push
collar over hose inlet until it `clicks´
into place.
6. Locate tabs on bag door as shown
and close bag door.
DO NOT use cleaner without bag in
place.
Hoover recommend that
filters are cleaned/
replaced after five full
bags have been removed.
CALLING FOR SERVICE
A charge will be made if the cleaner is found to be in working order or has not been
assembled in accordance with these instructions or has been used incorrectly.
Before calling a HOOVER Service Engineer run through the following checklist:
1. Is there a working electricity supply to the cleaner? Check with another
appliance.
2. Is the paper bag full?
3. Is the inlet blocked?
4. Are the filters blocked?
If there is any doubt call your local HOOVER Service Office for advice, they may be
able to assist you over the telephone.
22/6/07 16:34 Page 8
CHANGING THE FOAM
PRE-MOTOR FILTER* (8).
With paper bag removed lift the filter
from the bag housing.
Fit the new filter and replace the paper
bag.
WASHING THE HEPA PRE-
MOTOR FILTER (9)
With the paper bag removed, press the
HEPA pre-motor filter latch to unlock
the filter then tilt and remove it from
the filter housing. The filter is cleaned
by hand washing in warm water, and
allowing it to dry thoroughly before
refitting to the product.
recommends to clean the filter after
every 5 full dust bags.
To refit the filter, locate the tab on the
bottom of the filter frame into the
location on the filter housing. Tilt and
push the filter until the filter latch
engages and the filter is locked in place.
CHANGING THE EXHAUST
FILTER (10)
a) Lift off filter cover.
b) Peel off filter.
c) Fit new filter and replace cover.
* Feature varies according to model
GB
Hoover