Starting And Stopping - Haussmann CHT18LU Manuel D'utilisation

OPERATING INSTRUCTIONS
See table below:
Red Flashing
Green Off
Red ON Green Off
Green ON
Red Off
Green Flashing
Red Off
4. TO REMOVE OR INSTALL BATTERY
PACK (See B)
Fig B
Depress the battery release button to release
battery pack from your hedge trimmer. After
recharging, insert the battery pack into hedge
trimmer's battery port. A simple push and
slight pressure will be sufficient.
DO NOT USE THE PRODUCT WITHOUT
FIRST ATTACHING THE GUARD.
ASSEMBLY
Fitting the Safety Guard
Note: Your hedge trimmer may have its hand
guard fitted prior to purchase.
Before fitting the safety guard, first remove the
blade sheath. Fit the hand guard on the body
Defective battery,
after pre-charge 30
minutes with trickle
current, the total
battery voltage is still
less than 15.0V.
Charging
Power On and Fully
Charged
The temperature
of battery pack is
less than 0°C (32°F)
or more than 45°C
(113°F)
of the trimmer and secure with the two screws
(C)
Fig C
OPERATION

STARTING AND STOPPING

Before Starting Your Hedge Trimmer
Remove blade sheath.
To Start Your Hedge Trimmer
Your trimmer is equipped with two switch
levers (1 & 7). Both switch levers need to
be pressed for the hedge trimmer to start.
Depress and hold safety handle switch (1) and
press on/off switch (7) (See D)
To Stop Your Hedge Trimmer
Move hedge trimmer away from cutting area
before stopping.
To stop, release either the safety handle
switch (1) or on/off switch (7), the trimmer will
stop almost immediately.
If any parts are missing, damaged or
broken, do not operate your hedge trimmer
until all damaged parts have been replaced
or repaired. Failure to do so could result in
serious personal injury.
Fig D
A
17