AVIRE Connex-02 Manuel D'installation page 11

9.2.1.1 Lift in/out of Service
Reports on the "List Status Events" log either "Lift in service" or "Lift out of service"
when input is toggled.
9.2.1.2 Engineer on Site
When the "Engineer/Technician on Site" button (sold separately) is pressed to inform
the arrival of an Engineer, Connex-02 enters the "Engineer on site" mode and reports
on the "List Status Events" log "Engineer on site (local)". To exit the "Engineer on site"
mode to inform that the Engineer is leaving the site, the button should be pressed
once more where the event "Engineer off site (local)" is reported on to the "List Status
Events" log.
"Engineer off site"
In case of an Engineer leaves the site without pressing the button, simply press "Set
engineer as off site" button on the Avire Hub. This will report an "Engineer off site on
(remote)" the "List Status Events" log and force the device to exit "Engineer on site"
mode.
Additionally, it is possible to set a time-out for Connex-02 to automatically exit the
"Engineer on site" mode after the "Engineer/Technician on Site" button is pressed.
The time-out should be entered in minutes and the Connex-02 will exit "Engineer on
site" mode after this time has been elapsed and report to the "List Status Events" log
"Engineer off site (time-out)".
9.2.1.3 Lift in Maintenance
Reports on the "List Status Events" log either "Lift in maintenance" or "Lift off
maintenance" when the input is toggled
11