Cequent Performance Products REESE TOWPOWER 37096 Fiche D'instructions page 6

VEHICLE FRAME
EXISTING WELDNUT ON
BUMPER BRACKET
CENTER SECTION
NOTE:
General assembly - loosely assemble center section (page 1); loosely install side brackets on vehicle (this page);
install center section assembly; tighten all fasteners to proper specifications (page 1)
01- 07 CHEVROLET SILVERADO/ GMC SIERRA 2500HD PICKUP (07 – CLASSIC ONLY)
1. Remove the two (2) rear most M14 bumper bracket bolts.
2. Raise hitch side brackets and 3/8" bolt plate into position, aligning hole 3 in bracket with the rear most weldnut in frame.
3. Install the M14 x 45mm hex bolt and 9/16 lock washer though hole 3 and into weldnut in frame, both sides, finger tight.
4. Install 1/2" x 2 1/4" carriage bolt and block into hole of frame that aligns with hole 4 in hitch side bracket, as shown.
5. Install 1/2" x 2 1/4" hex bolt and block into hole of frame that aligns with hole 2 in hitch side bracket, as shown.
6. Install 3/8" bolt plate between frame and hitch side bracket at hole 2 and 4, as shown.
7. Finger tighten 1/2" conical washer and nut, both sides.
8. Install center section as pre-assembled on front page with (4) 3/8" x 1 ¼" bolts and washer nuts, both sides. Align
center section of hitch with center of vehicle. Finger tighten fasteners.
9. Tighten hitch side bracket to frame. Tighten side plate assembly to side bracket. Tighten side bracket assembly to
center section.
1/2" X 2 1/4" CARRIAGE BOLT
HOLE 4
HITCH SIDE BRACKET
HOLE 3
HOLE 2
1/2" CONICAL WASHER
1/2" NUT
3/8" WASHER NUTS
SIDE PLATE ASSEMBLY
M14 X 45mm BOLT
1/2" CONICAL WASHER
1/2" NUT
INSTALLATION B
1/4" x 1-1/2" x 3"
BOLT PLATE
1/2" x 2 1/4" HEX BOLT
TOOLS REQUIRED
9/16", 3/4" SOCKET
21MM SOCKET
TORQUE WRENCH
SAFETY GLASSES
3/8" x 1-1/4" x 2 1/2"
3/8" x 1 1/4 bolt
9/16" LOCK WASHER
BOLT PLATE
6