LUND EZ Mode D'emploi page 5

Passenger Rear Bracket Assembly:
Drill 5/16" hole for ¼" bolt,
washers and nylock nut (see
center bracket for reference)
4. Tighten the pinch weld bracket to the main brackets.
5. Center the board on the truck and then tighten the board to the main
brackets.
6. Double check to be sure all nuts and bolts are tight.
PRODUCT SPECIFIC WARNINGS:
Do not stand on boards while vehicle is in motion
Do not use boards to fasten cargo to vehicle
Do not exceed 350lbs weight on the running board
Do not use the bracket as a jacking point
Periodically check the bracket hardware for tightness
2003 Lund International, Inc. Lund Accessories Division, All Rights Reserved
775 Tipton Industrial, Lawrenceville, GA 30045
For customer service, please call 1-800-328-4843
For more information about Lund, please visit our website at
PN: 45041_A
0886
5
www.lundinternational.com
Drill 1/8" hole here for self-
tapping screw