Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
¼" Nylock
1. Assemble brackets as shown above. Do not tighten.
2. Assemble brackets to pre-assembled running board (per running board
instructions) do not tighten yet. Refer to step 3 for bracket placement.
3. Place brackets in mounting locations as shown below. Mark, center punch, drill
and attach and tighten as noted. NOTE: PLACE A SMALL BEAD OF SILICONE
IN ALL DRILLED HOLES.
Front Brackets:
Drill 5/16" hole for ¼" bolt,
washers and nylock nut (see
center bracket for reference)
0884
2003 Lund International, Inc. Lund Accessories Division, All Rights Reserved
775 Tipton Industrial, Lawrenceville, GA 30045
For customer service, please call 1-800-328-4843
For more information about Lund, please visit our website at
PN: 45041
¼" Bolt
Pinch Weld
www.lundinternational.com
3
X 6
Parking Brake
Cable (Drivers
Side ONLY)
Drill 1/8" hole up for self-
tapping screw
Chassis
Publicité
Table des Matières
