Technical Specifications; Warranty Procedure - Safescan 1550 Mode D'emploi

• The tension of the feed belt can be adjusted by adjusting the
position of the nut 1.
• The height of the front feed pulley can be adjusted by adjusting
the position of screw 1.
• The height of the rear feed pulley can be adjusted by adjusting
the position of the screw 2.
• Then tighten the nut 1, nut 2 & nut 3.
• Remove the rubber washer on the Plastic pedal; unscrew the
four screws in the plastic pedal.
• Unscrew the screw 1 and screw 2, rotate the coin outlet chute so
you can unscrew it from the machine.
• Pull the bottom cover upward; remove the bottom cover from
the machine.
• Remove the V-belt 350 and fix a new belt on the pulley, the
tension can be adjusted by adjusting the position of the pressing
roller Base.

6.0 TecHnIcaL SPecIFIcaTIonS

counting Speed
Hopper capacity
countable coin size
Max. counting display
counting Mode
Power consumption
Power Requirements
Dimension
net Weight
7.0 WaRRanTy

WaRRanTy PRoceDURe

Contact Safescan for assistance: www.safescan.com or email support@safescan.com
08
2300 Coins/Min.
3600 coins (without the hopper extender installed for coins diameter of 15 mm
and thickness of 1.1 mm.)
12000 coins (with the hopper extender installed for coins diameter of 15 mm and
thickness of 1.1 mm.)
Thickness: 0.7 to 3.9 mm (.0275 to .154 inches)
Diameter :14 to 34 mm (.55 to 1.33 inches)
9999999
Continuous Counting Mode
Batch Counting Mode
Accumulation Counting Mode
70 W (During operation)
AC 120V ± 10%, 60Hz
or AC 220V ± 10%, 50Hz
270 (w) x 362 (d) x 240 (h) mm
10.63 (w) x 14.25 (d) x 9.45 (h) inches
11 kg or 24.2 lbs