Installing The Monitor; Connecting The Whole System - Conrad 75 10 59 Mode D'emploi

B) Installing the monitor
You should install the monitor on a flat, stable and, as much as possible, non-slip subsurface. For this, fold out the stand on the
rear. But it is recommended that this manner of installation be used only during test operation. Afterwards, it is best to mount
the monitor permanently on a flat vertical surface by means of suitable fastening material (screws / anchor fittings). It has a
mounting link for hanging. In some situations, using the threaded hole in the stand and screwing it on a tripod is also possible.
A wall outlet for energy supply should be as close as possible. When not using the system, take the network adapter out of the
wall outlet.
C) Connecting the whole system
Connect all components in accordance with the connection diagram. The colour-coding of plug and socket must agree except
for power supply connections. In this case, plugs are designated red, sockets black.
Ca 1
Au
Vi
Ex
Au audio
At power adapter
Ca camera
Cc camera cable (length ca. 18 m)
Vi Video
For system power supply, only use the suitable network adapter in connection with the line voltage prescribed for it.
Dn
Cc
Au
Vi
Dc
M
Ca 2
Au
Vi
Dc
Dc
Camera 1 Camera 2
Dc power supply (dircet current)
Dn Din cable
Ex A/V output
M monitor
1 power
2 GND
3 Video
4 Audio
Dn
Cc
Dc
Au
Vi
Vi
Au
At
17