Philips Azur Freemotion Mode D'emploi page 10

ENGLISH
12
Problem
The iron leaks.
Possible cause
The steam control is
set to .
The water tank is empty. Fill the water tank.
You are using a
temperature of below
2 dots.
Cordless iron cools
down after a while. It
needs to be recharged.
You are using steam
boost at a low
temperature.
You have used the
steam boost function
too often within a very
short period.
The water tank is
overfilled.
The water filling door
is not closed properly.
Solution
Set the steam control to
a steam setting (consult
Table 1 in Chapter "using
the appliance").
Consult Table 1
in Chapter "using
the appliance" for
temperature and steam
setting.
Put the iron back to its
base to heat up and dry
the soleplate.
Put the iron back to its
base to heat up and dry
the soleplate.
Consult Table 1 for use
of steam boost.
Put the iron back to its
base to heat up and dry
the soleplate. Use the
steam boost function
less frequently.
Do not fill the water
tank beyond the MAX
indication.
Make sure that the
water filling door is
closed properly.