4
STILTS ASSEMBLY
TOOLS NEEDED:
7/16" Wrench
7/16" Socket and Ratchet
#2 Phillips Screwdriver
SIDE POLES ASSEMBLY
1. Loosen Upper Side Pole Clamp bolt.
2. Loosen Lower Side Pole Bracket and remove bolt Side Pole.
3. Insert Lower Side Pole through the Upper Side Pole Bracket,
then insert it into the Lower Side Pole Bracket. Lining
Pole Clamp up the hole, carefully reinsert the bolt with
washer through both the bracket and pole. Add the second
washer and tighten the nut. Lift the pole to make sure
it is attached properly.
4. Slide the Upper Side Pole over the Lower Side Pole and
through the Upper Side Pole Clamp. Tighten the bolt so the
pole will not fall but can be moved and twisted.
HEEL CUP ASSEMBLY AND ADJUSTING
1. Install Heel Cup using the included screws, nuts
and washers. Leave Heel Cup loose for now.
2. Adjust Heel Cup on Foot plate to fit shoe. Slide Heel Cup
in or out to adjust length of Foot Plate so your leg
is aligned with the Upper Side Pole.
3. Make sure Heel Cup screws are fastened securely.
HEIGHT ADJUSTMENT
1. Stand or sit in a comfortable position to try
on the assembled stilt.
2. Remove Height Adjustment Knobs and pull Upper Legs
to the required length.
3. Place Leg Support Cuff on or above the calf muscle, below
the knee joint. Make sure the knee can flex properly.
4. Adjust the Upper Side Pole height by pulling up or pushing
down.
5. Remove stilt and tighten Upper Side Pole Clamp bolt
to secure height. NOTE: Do not over-tighten the clamp
as doing so can bend the tube and weaken the stilt.
SIDEWAYS ADJUSTMENT
1. Loosen Upper Side Pole Bracket bolt. This adjusts distance
between Foot Plate and Upper Side Pole.
2. While sitting, put stilt on.
3. Push or pull Side Pole so that knee is aligned over foot,
making sure leg is straight (knees not turned out).
4. Tighten the Upper Side Pole Bracket bolt.
UPPER SIDE POLE
UPPER SIDE
POLE BRACKET
UPPER SIDE
POLE CLAMP
LOWER SIDE
POLE
LOWER
SIDE POLE
BRACKET
LEG CUFF
CALF STRAP
ANKLE STRAP
HEEL CUP
TOE STRAP
FOOT PLATE
UPPER LEG
UPPER
ADJUSTER
DISK
LOWER
ADJUSTER
DISK
HEIGHT
ADJUSTMENT
KNOB
FLOOR SOLE