Depth Gauge; Installing The Shoulder Strap; Control Panel - Greenlee LRH-288 Manuel D'instructions

Operation—Power Tool (cont'd)

Depth Gauge

Loosen the support handle and adjust the depth
gauge to the desired depth. After adjusting, tighten the
support handle and fix depth gauge.
Depth gauge

Installing the Shoulder Strap

• Install the shoulder strap firmly to the main unit of
the tool. Check the length of the strap before use.
• Check the condition of the strap and do not use if
it is cut or torn.
• Wear the shoulder strap securely on the shoulder.
Failure to observe these precautions may result in
injury or property damage.
1. Pass the strap through the strap holders.
2. Pass the strap through the buckles and adjust the
length.
Shoulder pad
• The shoulder strap can be adjusted according
to the individual.
• Adjust the shoulder pad to the shoulder.
• Pull the shoulder strap to make sure it is firmly
attached to the main unit of the tool.
Depth of drilling

Control Panel

• DO NOT STARE INTO WORK LIGHT. Use of controls
or adjustments or performance of procedures
other than those specified herein may result in
hazardous radiation exposure.
• Do not use it as a substitute for a regular
flashlight.
(3)
LED Light (1)
Note: To use the LED light,
depress the trigger once.
Press the LED light button.
Pressing toggles the LED light on and off.
The light illuminates with very low current, and it does
not adversely affect the performance of the driver
during use or its battery capacity.
The built-in LED light is designed to illuminate the
small work area temporarily. After installing the battery
or if tool has been idle for more than 5 minutes, the
work light will not illuminate until the trigger has been
initially depressed.
This product has a built-in LED light. This product
is classified into "Class 1 LED Product" to IEC (EN)
60825-1:2001.
Class 1 LED Product
12
(1)
(2)