SICE S 62 E Manuel D'instructions page 86

While moving the automatic arm, the distance measured by the arm is shown on the display:
When the measurement is stored, the value of the distance acquired by the machine will
remain visible on the left display:
- if only one measurement is taken, the machine interprets the presence of a rim with
balancing using a clip weight on both sides (Dynamic Balancing Programme);
- moving the arm to the rest position, the machine will set up for the manual WIDTH entry;
- in this phase, it is possible to perform an additional acquisition of the rim diameter and
distance.
- Measure the width of the rim using the calliper provided (fig.12).
- Modify the width value displayed by pressing the
desired value is set.
The WIDTH can be set in millimetres or the values already set can be converted from
inches to millimetres by pressing the
Keep the
86
keys pressed to rapidly increase or decrease the previously
button.
S 62 E Operator's manual
11a
buttons until the