Set Up - Adhesive Weight Application Position - SICE S 62 E Manuel D'instructions

15.10. SET UP - ADHESIVE WEIGHT
APPLICATION POSITION
The machine makes it possible for the operator to select where the adhesive weight should
be applied based on his needs. To select this configuration, proceed as described below:
- press the
- use the
- press the
- use the
LASER line if present)
- press the
TYPE OF WEIGHT
TO BE APPLIED
Traditional clip
Adhesive
MOTORCYCLE
programme
Adhesive
Adhesive
Adhesive
Adhesive
112
key
keys to search for SEt UP
key to confirm
keys to search for ALU H.12 (ALU CLP – ALU H.6 using the
key to change the setting:
CONFIGURATION
SELECTED
H.12
LAS
(if applicable)
CLP
H.6
(failure laser)
WEIGHT APPLICATION POSITION
Always 12 o'clock
Always 12 o'clock
12 o'clock in all balancing programmes
TABLE A
using the weight-holder terminal in the
ALU1P/ALU2P balancing programmes, or
manually, taking the centre of the gripper
cavity as your reference for the midway
point of the weight, or using the 12 o'clock
position for ALU Statistics programmes
TABLE A
S 62 E Operator's manual