SICE S 62 E Manuel D'instructions page 102

- turn the wheel until it is in the position shown by the position indicators
- use chalk to make a double mark on the outer side of the tyre at the 12
o'clock position
Note: in this phase, press the
the first time the key is pressed, the actual unbalance values of the wheel as
currently mounted on the wheel balancer; the second time the key is pressed,
the obtained unbalance value continuing with the last phase of the optimisa-
OP.5
tion procedure with the improvement percentage; when the key is pressed for
the third time, the machine prepares for the last phase of the OPT programme
- remove the wheel from the wheel balancer
- on the tyre changer, move the double mark made in correspondence with
the valve
- press the
procedure.
Notes:
- The unbalance optimisation procedure can be quit at any time by pressing the
key; the displays will show the premature exit message:
Press the key to exit or the
- The following message could be displayed at the end of the first spin:
In this case it is advisable to exit the programme by pressing the key:
of the weights necessary for balancing the wheel are displayed. The programme execu-
tion is interrupted, thus not achieving the moderate improvement of the end results. By
pressing the
- At the end of the first spin the instruction that the tyre is to be mounted on the rim in
the reverse direction may appear. If you do not intend to reverse the tyre or if doing so
102
OPERATING PHASES
key to confirm and end the unbalance optimisation
Out
key the optimisation procedure can be continued.
key to display:
key to stay in the programme.
2
S 62 E Operator's manual
the values