Polaris TR28P Manuel Utilisateur page 6

3b.
Adjust Feed Hose Length to Fit Pool Length
1. Connect the Hose Assembly to the dedicated cleaner
return line opening by turning the Quick Disconnect
(m) clockwise into the UWF
secure.
2. Extend the end of the hose to the farthest point
of the pool. Do not include steps or seating areas.
3. The cleaner's optimal hose length should be within 6˝ (15cm), longer or shorter, of the
farthest point (see image). The hose portion that extends past the farthest point is the
hose overage. See hose adjustment instructions below.
Hose too long?
-
With the hose assembly laid on the deck, identify the Center Swivel (j).
-
Slide the Hose Floats away from the Center Swivel (j) and separate the swivel from the hose.
-
Cut half of the overage from each end of the hose sections that attach to the Center Swivel (j).
-
Reconnect hose sections with the Center Swivel (j) . Make sure the flow direction arrow (
the Center Swivel (j) points toward the cleaner.
Hose too short?
-
Add a Feed Hose section with floats, a swivel, and two hose nuts, available through your local
Polaris dealer. Do not add more than one 10 ft. (3m) hose section.
®
-
Adjust to proper length.
4. Position the first Hose Float (h) against the back-up valve (i) and the next Hose Float
within 2-3 ft (60-90 cm). Position the remaining Hose Floats (h) 1.5 - 3 ft. on the Hose
Assembly as shown.
1.5 ft - 3 ft
(45 - 90cm)
k
6
(n) and pulling away to
®
h j
n
m
+ / –
h
2 ft - 3 ft
(60 - 90cm)
g
) on
i