Polaris TR28P Manuel Utilisateur page 5

3
Adjust Hose Assembly
3a.
the Pool
h
m
l
1. Straighten the Hose Assembly by laying it out flat in the sun.
2. Identify the Leader Hose section (g), marked Polaris
3. Measure and mark the greatest depth of
the pool, usually at the main drain,
by using a telescopic pool pole.
4. Lay the telescopic pool pole next to the
Leader Hose (g) starting from the end of
the Leader Hose near the Back-Up Valve
(i). Transfer the water level mark from the
telescopic pole onto the Leader Hose (g).
NOTE: If the pool depth is 10 feet (3m)
or more, DO NOT cut the Leader Hose. Go to Section 3b: Adjust Feed Hose to Fit Pool
Length.
5. Cut the Leader Hose (g) at the mark (do not cut off the float). Detach the excess Leader
Hose from the swivel and discard.
6. Reattach the Leader Hose (g) to the Feed Hose (k) at the swivel.
NOTE: It is easier to reinstall the swivel when hose and swivel are wet.
Adjust Leader Hose Length to the Greatest Depth of
j
k
j
g
Leader Hose
Leader Hose.
®
greatest depth of pool
= greatest
depth of the
pool
i
g
water level mark
p
i
5