SYNQ SMP 12.22 Mode D'emploi page 9

ENGLISH
Then click on the Output tab and select USB Audio Codec. You may notice that the Volume slider sets itself
to the full level. You may notice that the Volume slider sets itself to the highest level. This will allow you to
use the level MAIN controls of the mixer to set the exact output level.
Recording to the USB I/O
For recording a live performance, you can send the main output mix to a computer by using the USBI/O
connector. The output signal will only be influenced by the individual channel settings and channel faders,
not by the MAIN L/R master output fader.
You can also assign the outputs of the AUX1 and AUX2 to the USB out, enabling you to build a stereo mix
for recording that's independent from the house sound system.
Press the USB SEND switch down to send the AUX1 and AUX2 mix to the USB input.
Playback from the USB I/O
For playback, the USB stereo signal goes directly via the TAPE IN to the MAIN OUTPUT mix of the console.
You can set the USB playback level by using the TAPE/USB volume knob.
SYNQ 13/118
®
OPERATION MANUAL
SMP12.22
ENGLISH
WIRING
SYNQ 14/118
®
OPERATION MANUAL
SMP12.22