Adjusting The Nail Penetration; Adjusting The Direction Of The Exhaust; Clearing A Jam From The Nailer - Campbell Hausfeld NB006750 Mode D'emploi

Operating Instructions
Operating The Nailer
(Continued)

ADJUSTING THE NAIL PENETRATION

The tool is equipped with an adjustable
depth of drive feature. This allows the
user to determine how deep a fastener
will be driven into the work surface.
1. Adjust operating pressure so nails
are driven consistently. Do not
exceed 110 psi.
2. To drive the nail shallower, turn
the wheel (C) to left to the extent
desired.
(C)
3. To sink a nail deeper, turn the wheel
(C) to right to the extent desired.
4. Make sure trigger and
work contact element
(WCE) move freely up
and down without
binding or sticking after
each adjustment.
ADJUSTING THE DIRECTION OF THE
EXHAUST
The tool is
Rotate
equipped
with an
adjustable
direction
exhaust deflector. This is intended to
allow the user to change the direction
of the exhaust. Simply twist the
deflector to any direction desired.

CLEARING A JAM FROM THE NAILER

1. Disconnect the air
supply from the nailer.
www.chpower.com
2. Remove
all nails
from the
magazine
(see
Loading/ Unloading). Failure to do
so will cause the nails to eject from
the front of the tool.
3. Undo latch by pulling
out and down. The wire
latch will disengage
from the hooks on the
nose.
4. The door can now be
rotated, exposing the
jammed fastener.
5. Remove the jammed
fastener, using pliers
or a screwdriver if
required.
6 Rotate door back into
the closed position.
7. Extend the wire latch
and place over the
hooks on the nose.
8. Close the latch by
pushing the latch up
and in until the latch
snaps into place.
9. Make sure the trigger
and work contact
element (WCE) move
freely up and down
without sticking or
binding.
6
Technical Support
Please call our Nailer Hotline at 1-800-
543-6400 with any questions regarding
the operation or repair of this nailer or
for additional copies of this manual.
Fastener And Replacement
Parts
Use only genuine
Campbell Hausfeld
16 gauge fasteners (or equivalent) - see
Fastener Interchange Information. Tool
performance, safety and durability
could be reduced if improper fasteners
are used. When ordering replacement
parts or fasteners, specify by part
number.
Nailer Repair
Only qualified personnel should repair
the tool and they should use genuine
Campbell Hausfeld replacement parts
and accessories, or parts and accessories
which perform equivalently.
Assembly Procedure For Seals
When repairing a nailer, the internal
parts must be cleaned and lubricated.
Parker O-lube or equivalent must be
used on all o-rings. Each o-ring must be
coated with O-lube before assembling.
A small amount of oil must be used on
all moving surfaces and pivots. After
reassembling, a few drops of 30W
non-detergent oil or equivalent, must
be added through the air line before
testing.