Quax CO-SLEEPER 01 01 62 Serie Manuel page 23

CO-SLEEPER
4. Assembling the cradle
Step 1 : Use the two leg frames and the connecting tube
Push the connection tube in the central PVC joint of a leg frame. Repeat with the other leg frame.
Step 2 : Use the cradle frame and the middle frame
Invert the cradle frame. Gently push the middle frame into the slots of the cradle frame. Repeat on the
other side.
Step 3 : Use the velcro straps of the cradle and the middle frame
Grasp the ends of the two velcro straps at the bottom of the cradle frame, connect them around the middle
frame and this on both sides.
Step 4 : Use the parts from step 1 and 3
Turn the cradle frame over, push it into the top of the leg frames and press until it is stuck.
Multifunctionele wieg
01 01 62-xx
Multifunktionale Wiege
Berceau multifonctionnel
Multifunctional cradle
Quax
First dreams
®
First steps
23