Select Cycle - Maytag MHW5500 Guide D'utilisation Et D'entretien

7.
Touch POWER/CANCEL to turn
on washer
Slowly close the Optimal Dispense drawer. Make sure the
drawer is closed completely, then touch POWER/CANCEL
to turn on the washer or go to Step 8.
8.

Select CYCLE*

Turn cycle knob to select your wash cycle. See "Cycle Guide"
for details on cycle features.
9.
Adjust settings, if desired*
The display will show the default settings for the selected cycle.
To adjust a setting, touch its name – Temperature, Soil Level, or
Spin Speed. Adjusting settings will change the Estimated Cycle
Time. Tightly packing the load, unbalanced loads, or excessive
suds may also cause the washer to increase the cycle time.
10.
Select any additional options*
To add an option to the cycle, touch its name – Fresh Hold,
Steam for Stains, Extra Rinse, Cycle Signal, or Control Lock.
To remove an option from the selected cycle, touch the
option again.
11.
Set detergent concentration
and water hardness
You can adjust the detergent concentration and water
hardness settings if needed. Default settings are 2x detergent
concentration and normal water hardness. If the detergent
concentration is not listed on the package, see "About
Detergent Concentration" to calculate the concentration.
To Adjust Dispenser Settings:
1. Touch – or + until the desired concentration appears on the
time display.
2. Touch WATER HARDNESS until the desired water hardness
appears on the time display.
* Not all options and settings are available with all cycles.
See "Cycle Guide" for available options and settings.
17