Rocking Loveseat Assembly Instructions - La-Z-Boy Reclina-Rocker Instructions

Rocking Loveseat Assembly Instructions

WARNING
– To reduce the risk of serious injury:
• Provide a clear path for operation of the back and legrest. Place tables and area rugs
at a distance to allow the legrest to fully extend without rubbing or interference.
1. Place the furniture in the desired location; refer to Furniture Placement Guide.
2. Proceed to Step 4 when joining a loveseat without a console.
3. Place the console (FIGURE 3) next to the right side (sitting) rocker recliner (FIGURE 1).
Move the console approximately 4" forward of the rocker recliner. Push the console back until
the truss head screws on the rocker recliner are engaged in both the front and rear brackets
on the console.
4. Place the left side (sitting) rocker recliner (FIGURE 2) next to the unit with the truss head
screws, either the right side (sitting) rocker recliner or the console. Move the left side (sitting)
rocker recliner approximately 4" forward of the unit with the screws. Push the rocker recliner
back until the truss head screws are engaged in both the front and rear brackets on the
rocker recliner.
5. Adjust the glides on the console to level the unit, if necessary. Turn clockwise to lower and
counterclockwise to raise.
NOTICE:
– To reduce the risk of product damage:
• The purpose of the latch bracket system is to connect the units and prevent them from
being separated. The latch bracket system does not provide adequate structural support
for the movement of latched units. Do not move the units while latched together, damage
may occur.
6. The units must be disconnected before moving the loveseat. To disconnect the units, press
the swing arm on the automatic latching bracket and slide the unit forward (FIGURE 4).
10
Rocking Loveseat Assembly Instructions
F 1
IGURE
Right Side (Sitting)
Rocker Recliner
F 2
IGURE
Left Side (Sitting)
Rocker Recliner
Base Connector
Subassembly
Base Connector
Front Subassembly
(with Automatic
Latching Bracket)
F 3
IGURE
Console
Side
Latch
Side Latch
Subassembly
(with Automatic
Latching Bracket)
Base Connector
Subassembly with
Truss Head Screw
and Bushing
F 4
IGURE
Base Connector
Front Subassembly
(Left Side Sitting
Rocker Recliner)
Side Latch
Subassembly
(Console)
11