Taking Measurement; Saving, Displaying And Deleting Measurements - Beurer BC 30 Mode D'emploi

mine what is affecting your blood pressure and which
variation may be seen as normal in your case.
• The accuracy of any blood pressure measurement with
this device can be affected by a multitude of causes.
Some can be avoided some have to be accepted at the
time of measurement. Speak with your physician about
possible causes affecting your blood pressure.
• Do not inflate the cuff unless wrapped around wrist.
• If no button is pressed for approx. two minutes the auto-
matic shutoff function shuts off the unit in order to pre-
serve the batteries.
• Do not touch the unit, cuff and/or press any buttons
when measurement is in progress, except for stopping
the measurement. Doing so may cause incorrect read-
ings.

6.4 Taking Measurement

• As described above, attach the cuff and adopt the
posture in which you want to perform the measure-
ment.
• Select the user memory
ment by holding the
check, during which all numbers appear, the cuff in-
flates automatically. Whilst the cuff is pumping up,
the device already calculates measurements for esti-
mating the necessary pump pressure. If this pressure
is insufficient, the device automatically pumps more
pressure.
or . Start the measure-
button. Following the display
• Then the pressure in the cuff is slowly released and
the pulse is detected.
• When the measurement has been taken, the remain-
ing air pressure dissipates very quickly. The pulse, the
systolic and diastolic blood pressure are displayed.
• Measuring can be cancelled at any time by pressing
.
• The symbol appears if the measurement could not
be performed properly. Take note of the chapter on
error messages/trouble-shooting in these instructions
for use and repeat the measurement.
• The device switches off automatically after 2 minutes.
Wait at least 5 minutes before taking another measure-
ment!

6.5 Saving, displaying and deleting measurements

Saving
Every successful measurement is stored along with its date
and time. If there are more than 60 measurements stored for
one user, the oldest measurement is deleted.
Press the Date/Time Set Button ( ) and then the User Se-
lect Button ( ) to select the desired user memory.
Confirm your selection with the button +/M.
You have 2 memories with 60 memory spaces each to store
the measurements of 2 different people separately or to
separate measurements taken in the morning and at night.
17