Silk-n ND-FM01 Guide D'installation page 6

EN
Charging
1. Connect the remote control
2. Plug the USB cable
3. Plug the other end of the USB cable
source. One to three indicator light(s) on the remote control
light up. When charging is complete, all four indicator lights are lit.
Assembling
1. Connect the remote control
2. Fasten the elastic straps
Operation
1. Assemble the product as described in Chapter "Assembling".
2. Thoroughly clean and dry the face and hands. Make sure they are
free from any makeup or dirt.
3. Sit or lie down and place the mask
elastic straps
4. Turn on the device and select the desired mode. The product has
two modes. In the Manual Mode a preferred treatment can be selected:
Red, Blue, Yellow or Purple LED light therapy. One treatment takes
10 minutes.
In the Automatic Mode a preferred treatment cannot be selected.
The product is activated in the following order: Red (5 min.), Blue
(3 min.), Yellow (4 min.) and Purple (3 min.) LED light therapy.
Manual Mode:
• Take the remote control
4
with Red LED light therapy by default.
6
When the battery is low, the indicator light on the remote
control will flash and the product will automatically shut
down after flashing 10 times.
into the charging port of the remote control.
6
to ensure the mask fits comfortably.
2
to turn on the device. It will enter into the Manual Mode
to the mask
3
into a compatible USB power
6
to the mask
3
to the mask
2 1
over your face. Adjust the
1
and long press the power button
3
.
1
.
1
.
will
3