Charging The Battery; General Information - Siku CONTROL Mode D'emploi

Charging the battery

Please only use the original SIKUCONTROL
battery charger to charge the storage battery.
A battery charger is also supplied with the
CONTROL tractor sets Art. No. 6753, 6754,
6756 and 6757.
Some information on how to use the
Power Pack and Charger
Charging of the batteries must be
carried out by adults only.
Always protect rechargeable batteries from dirt
and moisture and clean the contacts regularly
with a dry cloth.
If the storage battery is not in use, always
make sure the switch is clicked to "OFF".
1. Click operating switch to "OFF" position.
2. Carefully remove the storage battery from
the model.
3. Slide the storage battery into the slot of the
harger.
4. Connect the power pack to the charger and
then connect the plug of the power pack to the
mains. Only use an original SIKUCONTROL
power pack.
5. When the red control light shines, just switch
the charger to "ON". The green control light
flashes during the charging time. The storage
battery is fully charged as soon as the green
control light shines continuously.
6. Switch the operating switch of the storage
battery to "OFF" and disconnect the power
pack from the mains.
7. Withdraw the recharged battery from the
charger and insert it carefully into the model.
The operating switch is then on the left side
when looking towards the front of the tractor.
The Symbols
On / Off switch
Data interface for
additional equipment

General Information

After approximately 500 charges the storage
battery capacity will have slowly dropped
to about 80 % of the original capacity.
New batteries can easily be reordered with
Part No. 6702.
Declaration of warranty Page 18
7