Lanaform HELLO KITTY Manuel D'instruction page 5

• Never dismantle the base unit.
• If there is water leaking from the appliance or if there is an unusual smell during use, switch the appliance off
immediately and return it to the supplier or after-sales department.
• NEVER add any substance other than distilled or demineralised water to the tank, at a temperature of below 40°.
• Never switch on the humidifier when there is no water in the tank.
• Do not shake the appliance. This may cause the water to overflow into the base unit and prevent it from working
correctly.
• Never touch the water or the immersed components when the unit is switched on.
• To prevent damage to components, do not splash the inside of the base unit.
• Never scratch the transducer.
• In temperatures of below freezing (below 0°C), remove the water from the tank and the base to prevent the risk of
freezing.
• Do not use the humidifier if the air in the room is already humid enough (at least 50% relative humidity). Excessive
humidity is signalled by condensation on cold surfaces or cold walls in the room. To determine the humidity of the room
correctly, use a hygrometer, available from most hardware and department stores.
• It is advisable to use the appliance at a temperature of between 5 and 40°C and in a relative humidity of below 50%.
COMPONANTS
(Fig. 1)
1. Base unit
2. Control panel
3. ON/OFF
4. "Water presence» indicator light
5. Vapour output adjustment switch
6. 3 "Vapour output" indicator lights
7. Diffusion period adjustment switch
8. 4 "diffusion period" indicator lights
9. Tank
10. Spray
11. Tank handle
12. Water level detector
13. Transducer
14. Ventilator
15. Tank cap
16. Filter
17. Transformer
Hello Kitty
EN
5