Conglom transform QL014 Manuel De L'utilisateur page 10

Installation (continued)
PLACEMENT
Push the cabinet (A) against the wall. Level the unit
by adjusting the four leveling legs and checking
the alignment of the sink using a carpenter's level .
Please note, leveling feet are intended for leveling
the cabinet, not height adjustments . It is not
recommended to extend leveling feet by more than
Support mural
0.4" (10mm). Overextending the leveling feet may
render the sink cabinet unstable .
Armoire (A)
IMPORTANT: Due to the size and weight of this product,
it must be firmly attached to the wall using fastening
hardware that is appropriate for your wall type.
For drywall or plaster walls, it must be attached
to a wooden wall stud. Please consult a qualified
Coupe transversale de l'armoire
installation professional if necessary. Failing to do so Certaines composantes on été retirées pour plus de clarté
could result in property damage or personal injury.
Use silicone sealant to seal the sink to the wall and any
adjacent surfaces to keep those surfaces dry. Failing to
do so could result in moisture damage.
DRAINAGE
The tailpipe (not supplied) previously installed to the drain can now be connected to your household
plumbing. In some cases, your household plumbing will have to be modified
to ensure proper drainage . If so, please consult a licensed plumber to complete
needed modifications.
SUPPLY LINES (NOT INCLUDED)
Connect the supply lines to your home's water
supply as per manufacturer's instructions .
Open the hot and cold water supply valves and
check to make sure they have been installed to
appropriate inlet ports . Check for leaks . Run hot
and cold water uninterrupted for about one minute
to remove any residue from the lines .
10
QL014