Removing And Inserting The Hook-In Racks; Troubleshooting; Replacing The Oven Light Bulb - Siemens HG10LE150 Notice D'utilisation

Removing and inserting the hook-in racks

You can remove the hook-in racks for easier cleaning.
Removing the hook-in racks
The hook-in racks are each fixed to the side panels of the
cooking compartment at three points.
Grip the front of the hook-in rack and pull it to the middle of
1.
the cooking compartment.
The front hook of the hook-in rack will release from the hole.
Fold out the hook-in rack further and pull it from the rear
2.
holes of the side panel.
Hold the catalytic cooking compartment panel in place.
3.

Troubleshooting

Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service, as you may be able to
remedy the fault yourself.
:
Risk of injury!
Incorrect repairs are dangerous. Repairs may only be carried
out, and damaged power and gas lines replaced, by an after-
sales engineer trained by us. If the appliance is faulty, unplug
the mains plug or switch off the fuse in the fuse box. Shut off
the gas supply. Contact the after-sales service.
Malfunction Possible cause Solution
The appliance Power cut
does not work
Faulty circuit
breaker
The oven light- Oven light is
ing has failed. faulty
The flame Normal build-up
(oven) does not of dirt
burn through all
outlet openings.
The door panel Normal occur-
steams up rence; caused
when the oven by the differ-
heats up. ence in tempera-
ture
--------
Check whether other
kitchen appliances are
working
Check in the fuse box to
make sure that the circuit-
breaker for the appliance is
OK
Replace the oven light.
(See section "Replacing
oven light")
The burner must be profes-
sionally cleaned.
Not possible; this has no
effect on oven performance.
Remove the hook-in rack from the cooking compartment.
4.
Inserting the hook-in rack
Hold the catalytic cooking compartment panel in place.
1.
Insert the hooks of the hook-in rack into the rear holes in the
2.
side panel.
Press the front hook of the hook-in rack into the hole.
3.

Replacing the oven light bulb

If the oven light bulb fails, it must be replaced. Replacement
heat-resistant bulbs can be obtained from the after-sales
service or from specialist retailers. Please specify the E number
and FD number of your appliance. Do not use any other type of
bulb.
:
Risk of electric shock!
When replacing the cooking compartment bulb, the bulb socket
contacts are live. Before replacing the bulb, unplug the
appliance from the mains or switch off the circuit breaker in the
fuse box.
Allow the cooking compartment to cool down.
1.
Open the appliance door.
2.
Place a tea towel in the cooking compartment to prevent
3.
damage.
Remove the hook-in racks.
4.
Remove the glass cover. To do this, open the glass cover at
5.
the front with your hand. Should you experience difficulties
removing the glass cover, use a spoon to help.
Remove the oven light bulb.
6.
Replace the oven light bulb with a bulb of the same type:
7.
Voltage: 230 V;
Power: 40 W;
Fitting: G9;
Temperature resistance: 300 °C
Refit the glass cover for the oven light bulb.
8.
Refit the hook-in racks.
9.
Remove the tea towel.
10.
Switch the circuit breaker back on.
11.
Check that the oven lighting is working again.
12.
11