Safety Precautions - Panasonic FZ-VEBX111U Instructions D'utilisation

Safety precautions

R Do not disassemble or modify the cradle.
Short-circuit or overheating may result, which could lead to fire or electric shock.
R Do not insert foreign objects into the cradle.
This may cause the battery to short circuit or overheat, which may result in fire
or electric shock.
R Use only specified AC adaptors.
Use of unspecified AC adaptors may result in overheating, fire, or rupture.
R Use only specified batteries.
Use of unspecified batteries may result in electrolyte leakage, overheating, or
rupture.
R Stop using the cradle if any of the following occurs.
– Cradle emits smoke, unusual sound, or unusual smell
– Water or foreign object enters the cradle
– Cradle is damaged
– Cradle becomes unusually hot
Failure to do so may result in fire or electric shock. Disconnect the cradle from
the power supply, remove the unit, and then contact your technical support
representative for support or repair.
R Do not touch the cradle or cables during lightning storms.
There is a remote chance of electric shock.
R Do not splash water on the cradle or allow it to become wet.
These may result in smoke or fire.
R Do not place the cradle on an unstable surface.
The cradle may drop, resulting in injury.
R Do not leave the cradle in extremely high temperature environments for an
extended period.
Leaving the cradle where it will be exposed to extremely high temperatures,
such as near fire or in direct sunlight, may deform the cradle or cause damage
or malfunction to its internal components. Using the cradle in these conditions
may cause short circuit, insulation defects, etc., which may in turn cause fire or
electric shock.
R Do not leave the cradle in areas with a high concentration of moisture,
steam, dust, oily vapors, etc.
Foreign material that enters the cradle may cause fire or electric shock.
R Use the LAN port for connecting to specified network equipment only.
Connecting to unspecified equipment could result in fire or electric shock.
Connect only 100BASE-TX or 10BASE-T equipment to the LAN port. Do not
attempt to connect phone cables or other types of cables.
6