Dyna-Glo DGA480SSN Mode D'emploi page 9

ASSEMBLY INSTRUCTIONS
5. Remove preassembled screws (GG) from the
door handles (J). Insert 2 door handle sleeves
(K) into the holes located on the back of the left
door assembly (H). Insert 2 screws (GG) into
the door handle sleeves (K) and into the
threaded holes in the door handle (J).
Tighten the screws.
Repeat with right door assembly (I).
Hardware Used
M4 x 10 Screw
GG
(preassembled)
6. Attach the left door assembly (H) to the cart
body by aligning the holes in the hinge of the
left door assembly (H) with the holes in the
cart left side panel (D), inserting 4 screws
(DD) and tightening.
Repeat with right door assembly (I).
Hardware Used
DD
M4 x 10 Screw
5
x 4
6
DD
x 8
9
GG
J
K
D
H
H
E
I