Know Your Machine - U.S. Products Solus 310R Directives D'utilisation

A - ENGLISH

KNOW YOUR MACHINE

1 VACUUM LID - This lid provides access into your recovery tank so that you can clean the tank. The lid must be closed before you try to clean.
2 SOLUTION TANK FILL HOLE - This is where you fi ll the tank with water and cleaning solution.
3 VACUUM HOSE BARB - This is where you connect your vacuum hose to the machine. A tight connection is necessary to prevent a vacuum leak which
would reduce the amount of suction.
4 DRAIN HOSE - This is how you empty the dirty water from your recovery tank. Place the hose over a drain, and open the cap. When cleaning out the tank
at the end of a job, simply place this hose into a drain and use clean water to rinse out the dirt and debris from the tank. NOTE: be sure to close the cap
tightly before using the machine again.
5 HANDLES - The handles are used to move the machine. These handles
allow you to tilt the machine back onto its 12" wheels for easy maneuvering,
and/or for moving on stairways.
6 SWITCH PLATE - The switches are located on the rear of the machine, out
of the way of water.
7 FAN - Removes warm air from the component compartment.
8 PSI GAUGE - indicates the pump pressure. Look at the pressure while you
spray.
9 LATCH - The latch holds together the tank and the base compartment.
10 SOLUTION HOSE QUICK CONNECT - This is where you connect the
solution line that runs from the machine to the carpet wand or hand tool.
11 POWER CORD RECEPTACLES - The receptacles are where the two power
cords connect to the machine.
12 CASTOR - Swivel castor provides easy maneuverability.
13 WHEEL - The rear wheels are 12 inches in diameter to provide superior
ease of transportation and stair climbing.
5
2
6
INSTRUCTIONS FOR USE
8
SOLUS 310R-PFR - 56091035
®
1
12
3
4
10
9
11
7
13
6
11
5/08