Unpacking And Setup - auna Bella Ann Mode D'emploi

UNPACKING AND SETUP

• Carefully remove the unit from the display carton and remove all
packing material from the unit.
• Unwind the AC power cord and
extend it to its full length.
• Unwind the FM Antenna wire and
extend it to its full length.
• Place the unit on a stable level
surface, which is convenient to an
AC outlet out of a strong magnetic
field.
• Connect the plug to your AC outlet.
• Raise the lid to expose the
phonograph. The phonograph has
been secured for shipment with a
transit screw.
• Use a coin or screwdriver to turn the transit screw clockwise.
• This will allow the turntable to "float"
• Remove the opaque white plastic stylus cover from the phonograph
stylus by sliding it in the direction of the arrow.
• During this operation pay attention to the stylus, because the stylus
damage is not covered by guarantee.
• Remove the twist-tie that was used to secure the tone arm during
shipment.
• Release the tone arm lock lever.
• Connect the plug to your AC 230V,50Hz outlet.
transit screw
tone arm lock lever
stylus cover
EN
27