Product Overview; Description Of Function; Sensors; Transformer - AL-KO Solo Robolinho 1000/100 Mode D'emploi

Product overview

PRODUCT OVERVIEW
The product overview (2) provides an overview of
the machine.
2-1 Operating panel (under cover flap)
2-2 Charging contacts
2-3 Bumper
2-4 Deck
2-5 Cover plate (flap for height adjustment)
2-6 Height adjustment interior
2-7 STOP key
2-8 Front rollers (steering)
2-9 Blade plate
2-10 Drive wheels
2-11 Cutting blade
2-12 Clearer blade

DESCRIPTION OF FUNCTION

The Robolinho is a fully automatic, bat-
tery-operated lawnmower which moves freely
within a defined mowing area.
The mowing area is defined by a boundary
cable that is connected to the base station.
In order for its battery to be recharged, the
Robolinho moves along the boundary cable
into the base station.
Mowing programs are pre-installed for mo-
wing, and also include the lawn and edge mo-
wing function. These mowing programs can
be changed.
The special arrangement of blades means
that the mown grass is not gathered up but
remains on the lawn between the stalks of
grass. As a result, it has a mulching or fertili-
sing effect.

SENSORS

The Robolinho is equipped with various safety
sensors (9).
Lifting sensor
If the Robolinho is lifted up by its deck during
operation, a sensor stops the blade within 2
seconds and switches off the travel drive.
456403_a
Bump sensors and obstacle detection
The Robolinho is equipped with sensors that
ensure it changes its direction of travel if it
encounters obstacles. When it encounters an
obstacle, the top part of the deck (9-1) is shif-
ted slightly. This causes a sensor to trigger a
change in the direction of travel.
Tilt sensor in direction of travel
The Robolinho is switched off by the tilt sen-
sor if it encounters an upward or downward
slope of more than 35%.
Tilt sensor on side
The Robolinho is switched off by the tilt sen-
sor if it encounters sideways slopes of more
than 35%.
ADVICE
The Robolinho does not restart automa-
tically after being switched off by a safety
sensor. To restart, it is necessary to ack-
nowledge the fault by pressing the multi-
function key and rectifying the fault.

TRANSFORMER

The transformer generates the electricity for the
base station.
WARNING!
Damage due to splash water!
Set up the transformer in a dry place
where it is protected against splash wa-
ter.
We recommend the connection via a
earth leakage circuit breaker (ELCB)
with a rated leakage current < 30 mA!

ASSEMBLY

ADVICE
It is essential to comply with the se-
quence described here
CAUTION!
Danger - risk of injury!
Always ensure stability when working!
Wear work clothing and protective gear.
27