Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.-
: allows you to change the play and repeat mode of the player (repeat all, repeat folder, repeat 1 and
random play).
8.-
: a short press of this button starts/pauses playback. A long press displays the folder in playback.
9.-
VOL: wireless microphone volume control.
10.-
RF: radio frequency signal level indicator light.
11.-
Power indicator light for the wireless receiver module.
12.-
ON/OFF: switch that activates/deactivates the wireless receiver module of the portable speaker.
13.-
AUX INPUT: line level stereo aux input, 2 x RCA connectors.
14.-
MIC: balanced microphone level input, XLR connector.
15.-
VOL: microphone input volume control.
16.-
MP3 PLAYER VOL: volume control for the aux input and MP3 player.
17.-
ECHO: control for adjusting the number of repetitions of the echo effect of the microphone input.
18.-
MASTER: output volume control for the final mix of all inputs.
19.- Indicator light to indicate the operation of the speaker with battery.
20.- Low battery indicator light. The speaker battery must be charged.
21.-
CHARGING: recharge indicator light.
To charge the battery of the portable speaker, connect it to the mains socket and switch on the speaker
with the switch located at the bottom of the rear panel of the device.
22.-
POWER: power indicator light of the portable speaker.
23.-
CLIP: peak signal indicator light. It lights up when an input signal is detected with a very high level or
when there is an excessive output level that can cause damage to the equipment.
24.-
BASS: control that reinforces or dims the low frequencies, ±10 dB.
25.-
TREBLE: control that reinforces or dims the high frequencies, ±10 dB.
26.-
POWER: general on/off switch of the speaker.
27.- Input to connect the AC power cable.
HANDHELD MICROPHONE
1.-
BATT: operation and low battery indicator light. When the battery charge is optimal, the indicator light
remains lit. When the battery charge is low, the indicator light remains on with less intensity. Replace
the batteries with new ones.
2.-
Hand-held microphone on/off switch. In addition, this selector has a third MUTE position to mute the
audio output with the microphone on.
3.-
Battery compartment. Use 2 LR6-AA 1.5 V batteries, preferably alkaline. When inserting the batteries,
make sure the polarity is correct.
1
2
3
- 3 -
EN
Publicité
Table des Matières
