Product Warranty - Redmond RHB-2920-E Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 9
2. Fit the S-shaped blade on the central pin at the bottom of the chopper
bowl. Note: the blade is very sharp, handle with caution! Always hold the
blade by the plastic collar.
3. Fill the bowl with food. Do not fill above the maximum fill mark. Follow
the procedures outlined in "General Guidelines" section.
4. Fit the lid onto the bowl, aligning the crosspiece of the plastic collar with
the corresponding notches in the centre of the lid. Align the projections
on the sides of the lid with the corresponding notches on the bowl edges.
Gently press the lid down and rotate in the clockwise direction until it
clicks into place.
5. Press and hold both fixation buttons simultaneously and connect the
motor unit with the fixation hole on the bowl lid.
6. Plug in the appliance. Select the speed setting: harder foods require
higher chopping speed. Turn the speed control knob in the clockwise
direction to increase the speed.
7.
Steadily holding the vessel with one hand press and hold down the Power
or Turbo mode button. Use Turbo mode for meat and other tough foods.
8. After the use unplug the appliance. Press and hold both fixation buttons
simultaneously and disconnect the motor unit.
9. Remove the S-shaped blade holding it by the plastic collar.
10. Clean the appliance in accordance with the table A1.
III. BEFORE CONTACTING SERVICE CENTRE
Problem
Power cord is not connected to an electrical outlet, voltage failure in electri-
Appliance does
cal outlet. Connect power cord to an electrical network. Connect the appliance
not work
to properly working electrical outlet.
Strong vibration
occurs during
Food pieces are too large. Cut food into smaller pieces.
operation
Appliance is overheated. Reduce continuous operation time. Increase intervals
between switching.
Plastic smell
during use
Appliance is new; the smell is coming from protective cover. Thoroughly clean
the appliance (ref. table
IV. PRODUCT WARRANTY
We warrant this product to be free from defects for a period of 2 years from the
date of purchase. If the appliance fails to operate properly within the warranty
8
Possible causes and solutions
A1
).The smell will disappear after few uses.
period and is found to be defective in material or workmanship, we will repair or
replace it free of charge. This warranty comes into force only in case an original
warranty service coupon with a serial article number and an accurate impress of
the company of the seller proves the purchase date. This limited warranty does
not cover damage caused by the failure to use this product for its normal purpose
or in accordance with the instructions on the proper use and maintenance of the
product or any kind of repair works. Do not try to disassemble the device and keep
all package contents. This warranty does not cover normal wear of the device and
its parts (filters, bulbs, ceramic and Teflon coating, gaskets etc.).
Service life and the applicable product warranty period start on the date of
purchase or the date of manufacture (if the purchase date cannot be established).
You can determine manufacture date by serial number, located on the identifi-
cation label on the housing of the device. The serial number consists of 13
digits. 6th and 7th digits of the serial number identify the month, 8th digit the
year of manufacture.
Service life of the product, established by the manufacturer is 3 years from the
date of purchase, provided that the unit is used and maintained in accordance
with the user manual and applicable technical standards.
The packaging, user manual, and the device itself may not be treated as house-
hold waste. Instead, it shall be taken to the applicable collection point for the
recycling of electrical and electronic equipment.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Rhb-2925-e

Table des Matières