Chauvet DJ Geyser P6 Manuel De Référence page 4

Geyser P6 QRG
Product Overview
AC Power
Fuse
Replacement
Fluid Line In
Removable Shield
On/Off Switch
Power In
Fuse Holder
FCQ (Fog Cleaner Quart) was specifically developed by
CHAUVET to clean your Geyser P6 Make sure you use FCQ
regularly to increase the life of your product.
This product has fixed-voltage power supply that can work with an
input voltage of either 120 VAC, 50/60 Hz or 230 VAC, 50 Hz.
1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse
holder.
3. Pry the safety cap out of the housing.
4. Remove the blown fuse from the clip on the front of the safety cap
and replace with a fuse of the exact same type and rating.
5. Re-insert the fuse holder and reconnect power.
Fluid Tank
LED Display
Control Buttons
Remote Control
Receiver Port
EN
Nozzle and LEDs
DMX
In/Out