Waldbeck Yukon Mode D'emploi page 46

EN
46
for you to determine the exact location, it gets the digging difficult. At this
time, you should recur to the PINPOINT mode.
a. Touch the PINPOINT button, the PINPOIT cursor is lighted, and the
depth cursor will be full scale. The detector will sound a low single-
frequency tone, the sensitivity is in the highest state.
b. Let the search coil approach the ground, move the search coil slowly in
the region, where you find the target. In the position where the single
frequency tone turns louder, and the signal strength cursor begins to
appear. Continue moving the search coil slowly until the sound turns
more louder, the signal strength cursor is full scale, and the depth cursor
is the lowest.
c. Maintain the position of the detector, exit the PINPOINT mode. Touch
the PINPOINT button again later, the detector will be self-balanced,
and sound a low single frequency tone, the signal strength cursor will
be extinguished, the depth cursor will be full scale. Move the search
coil slowly again, let the single frequency tone turn more louder, and
the signal strength cursor increase, the depth cursor turn to the lowest,
which means the position of the metal target has been locked. By the
center of the open search coil, mark on the ground, to facilitate mining.
d. Repeat the operation for several times and approach the target for
several times, until you lock the location of the metal target. You could
make notes on the ground by the center of the open search coil, to
facilitate your excavation.
e. In the process of the PINPOINT, the depth cursor will turn to the signal
strength cursor, which denotes the distance between the center of the
search coil and the target, to help you pinpoint the location. Finally, the
depth cursor will remain at the lowest gear. In fact, it means the target is
the nearest from the center of the search coil.
7. Depth and Target Indication(only in the motion mode)
The detector is preset in the motion mode. The LCD screen will show the
rough metal target types and the rough target depth.
When the position and type of the target are determined, the detector will
send a repeated signal. If you detect in the same place, while the discrimination
display is inconsistent, which means the target may be false, or it may be the
trash metal or heavily oxidized metal. Trough practice, you must bear in mind
only repeatable signal existent, then you do excavation.
When find a metal target, the identification cursor will indicate the metal type.
Silver is on the right. In the neutral soil, the identification indication is more